Alinco EJ-41U Bedienerhandbuch PDF herunterladen (Seite 44)

Appendix

TNC Commands List

The commands supported by the built-in TNC are list below. You must enter a space between a

command name (or short-form) and a parameter, or between two parameters; ex.AU OFF.

Command form

Default Parameters Description

Name Short

AUTOLF AU ON ON/OFF When ON, sends a line feed (LF) to the PC after each

carriage return (CR).

BEACON B EVERY 0 EVERY/ If set to EVERY, sends a beacon packet at intervals of the

AFTER n specified period (n). If set to AFTER, sends a beacon packet

( n=0 - 250 ) only once after the specified period (n). The unit of n is 10

seconds.

BTEXT BT - 0 - 159 Specifies the content of the data portion of a beacon

characters packet.

CALIBRAT CAL - - Sends a space/mark square wave (50/50 ratio). Enter

Q to exit Calibrate mode and restore the Command mode.

CHCAK CH 30 0 - 250 Specifies the interval from signal drop-out until execution

of disconnection. The unit of the parameter is 10 seconds.

CONNECT C - Call1 (VIA Sends a connect request. Call 1 is the call sign of the station

call1, call3, to be connected to. Calls 2 to call 9 are call signs of stations

....call9) to be digipeated through.

CONVERSE

CONV - - Causes the TNC to enter Converse mode. Press [Ctrl]+[C]

or K to restore the Command mode.

CPACTIME CP OFF ON/OFF When ON and in Converse mode, sends a packet at inter-

vals of the period determine by PACTIME

CR CR ON ON/OFF When ON, appends a carriage return (CR) to all packets to

be sent.

DISCONNE D - - Sends a disconnect request.

DISPLAY DISP - -

Causes the TNC to display the current status of all the com-

mands. You can also specify a class identifier A, C, H, I, L,

M, or T to display the status of only the desired command

class. Enter a space between the command name and a class

identifier; ex. DISPLAY H.

A (ASYNC): RS-232C port parameters.

C (CHAR) : Special TNC characters.

H (HEALTH): Counter parameters.

I (ID): ID parameters.

L (LINK): TNC-to -TNC link status.

M (MONITOR): Monitor parameters.

T (TIMING): Timing parameters.

DWAIT DW 30 30 Specifies the interval from no carrier detection until execu-

tion of transmission. The unit of the parameter is 10 milli-

seconds.

ECHO E ON ON/OFF When ON, causes the TNC to echo received characters to

the computer.

1 2 ... 39 40 41 42 43 44 45 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Alinco EJ-41U Bedienerhandbuch Seite 44

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen Alinco EJ-41U