Alinco DX-SR8 Spezifikationen PDF herunterladen (Seite 3)

AL-100 Operations Manual Version 1.0

INTRODUCTION

LDG pioneered the automatic, wide-range switched-L tuner in 1995. From its

laboratories in St. Leonard, Maryland, LDG continues to define the state of

the art in this field with innovative automatic tuners and related products for

every amateur need.

Congratulations on selecting the AL-100 100-watt automatic tuner for the

Alinco HF transceivers. The AL-100 provides semi-automatic antenna tuning

across the entire HF spectrum, at power levels up to 100 watts. It will tune

dipoles, verticals, Yagis, or virtually any coax-fed antenna. It will match an

amazing range of antennas and impedances, far greater than some other

tuners you may have considered, including the built-in tuners on many radios.

The AL-100 is similar to previous LDG tuners, but is specially engineered to

integrate with Alinco HF radios.

The AL-100 connects to the 5-pin tuner port on the back of the radio. The AL-

100 is powered by the Alinco radio over the tuner interface cable, and tuning

is greatly simplified -- you use the TUNE button on the transceiver to start an

automatic tuning cycle.

Jumpstart, or “Real Hams Don’t Read Manuals”

1. Turn off power to your Alinco radio.

2. Connect the HF antenna jack on the transceiver to the “TX” jack on the AL-

100.

3. Connect your antenna’s 50 ohm coax antenna feedline to the “ANT” jack

on the AL-100.

4. Connect the 4-pin mini-DIN end of the supplied radio interface cable to the

“Radio” jack on the AL-100.

5. Connect the other end of the radio interface cable to the radio’s 5-pin tuner

jack.

6. Turn on the radio and select the desired operating frequency and mode.

7. Consult your radio’s manual on how to activate the external tuner. On most

Alinco HF radios, press FUNC and then TUNE. The transceiver

automatically keys up with a minimal amount of power, and the AL-100

begins a tuning cycle. At the end of the tuning cycle, the original mode and

power level is restored.

8. You’re now ready to operate!

The

100

custom made for

Alinco transceivers,

and uses your

radio’s TUNE button.

You

should

really

read the whole

manual, but this

summary will get

you started.

1 2 3 4 5 6 7 8 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Alinco DX-SR8 Spezifikationen Seite 3

Kommentare zu diesen Handbüchern