Alinco DJ-596T Bedienerhandbuch

ALINCO, INC.VHF FM TRANSCEIVERDJ-175 T/E/TFHInstruction ManualThank you for purchasing your new Alinco transceiver.This instruction manual contains im

10ContentsContentsNOTICE / Compliance Information Statement...2Warning...

11Contents4.7 Receiving ...284.7.1 Monitor Fu

12Contents7.Special Functions...407.1 Battery Refresh ...

1.Features1131. FeaturesThis transceiver has the following main features.39 CTCSS tone squelch104 DCS digital code squelchTime-Out-TimerAlphanumeric d

2.Accessories2142. Accessories2.1.1 AntennaAttaching the Antenna1. Hold the antenna by its base.2. Align the grooves at the base of the antenna withth

2.Accessories2152.1.3 Belt ClipAttaching the Belt ClipAttach the belt clip to the back of the transceiver untilit clicks.Removing the Belt ClipPush up

2.Accessories216Caution• The battery pack isn't fully charged when shipped. It must be chargedbefore use.• Charging should be conducted in a tem

2.Accessories2172.1.5 Prevent Short Circuiting the Battery PackBe extra cautious when carrying the rechargeable battery pack; short circuiting willpro

3.Names and Operations of Parts3183. Names and Operations of Parts① ⑤ ⑥ ⑨ ⑩ ② ③ ④ ⑪ ⑫ ⑧ ⑦ Names and Operations of Keys and Ports3.1

3.Names and Operations of Parts319⑨ ⑩ ⑪ ⑫ Power keyKeypadMicrophone/Speaker jackDialPress the power key down for approximately one second to turn on

NOTICE / Compliance Information Statement2NOTICE / Compliance Information StatementThis equipment has been tested and found to comply with the limits

3.Names and Operations of Parts320keyWithout pressing the FUNC key.Inputs* 1.Inputs 2.Inputs 3.Inputs 4.Inputs 5.Inputs 6.Inputs 7.Inputs 8.Inputs 9.I

3.Names and Operations of Parts321① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩ ⑪ ⑫ ⑬ ⑭ ⑮ ⑯⑰ Appears when the FUNC key is pressed.Indicates the shift (+/-) direction.Appears

4.Basic Operation4224. Basic OperationHold the key down for a second. To turn off the power, hold the key down untilthe display turns off.• There ar

4.Basic Operation423The factory default of this unit is the VFO mode. The VFO mode allows you tochange the frequency and operating parameters by usin

4.Basic Operation4244.4.2 Setting the Tuning Step1. Press the FUNC key in the VFO mode, and while is displayed, press the key to display the current

4.Basic Operation4252. Each time the key is pressed the shift direction changes as indicated below.A (-) means that the TX frequency is lower than th

4.Basic Operation4264.5.2 Recalling a Memory Channel1. Select the Memory mode by pressing the key. " " and channel numberappear on the dis

4.Basic Operation4274.5.5 Programmable Parameters in Memory ChannelsThe following parameters can be stored in each of the memory channels.• Frequency

4.Basic Operation4281. Turn on the unit.2. Press the key and rotate the dial to adjust the audio level as necessary.3. Press the key and rotate the

4.Basic Operation4294.8.1 Selecting the Output LevelPress the FUNC key, and while is displayed on the LCD, press the key toswitch transmission power

NOTICE / Compliance Information Statement3Conformity InformationAlinco, Inc. Electronics Division hereby declare on our sole responsibility that thepr

5.Useful Functions5305. Useful FunctionsThe scan function automatically searches the receiving signals. There are 2 modes forscan-resume condition.•

5.Useful Functions5315.1.3 Setting Skip ChannelsYou can select the memory channels that you wish to skip during the memory-scan.• Press the FUNC key i

5.Useful Functions532In the Memory mode, it is possible to display up to 6 alphanumeric characters (Name-tag) instead of conventional frequency displa

5.Useful Functions533This function prevents an useless battery consumption.5.5.1 Setting APOPress the FUNC key, and while is displayed on the LCD, pr

5.Useful Functions534Press the FUNC key, and while is displayed on the LCD, press the MONI key toilluminate the display and DTMF keypad.• The backlig

6.Selective Calling6356. Selective CallingSelective Calling Operations• To communicate only with selected stations, use either the Tone Squelch or the

6.Selective Calling6366.1.2 Switching Off the Tone SquelchPress the key in Tone Squelch Setting mode to select TCS-OF, then press anykey other than t

6.Selective Calling6376.2.2 Changing the DCS Code1. Rotate the dial in DCS Code Setting mode (while " " is displayed).2. Press any key other

6.Selective Calling638Advantage of DETIt enables DCS squelch operation even in poorer signal conditions.Disadvantage of DETWhen it is activated, suppo

6.Selective Calling6393. Use the DTMF key to input the DTMF tones.For example: when programming 123456789, the display changes as follows:[ 1

Warning4WarningTo prevent any hazard during operation of Alinco's radio product, in this manual andon the product you may find symbols shown belo

7.Special Functions7407. Special FunctionsRepeating improper recharge of the Ni-MH battery pack may cause so-called the"memory effect" that

8.Set Mode8418. Set ModeThe Set mode is used to customize the various operational parameters of your DJ-175.This chart shows the available parameters

8.Set Mode8428.3.1 Menu 1 Battery Save (BS) FunctionThis function prevents useless battery consumption by switching the power ON/OFFat a fixed ratio

8.Set Mode8438.3.5 Menu 5 Clock Shift SettingIn the unlikely event that you may hear a weak noise always on the same frequency, itmay be so-called a

8.Set Mode8448.3.7 Menu 7 TOT Penalty TimeThis parameter determines the time to resume the transmission after the unit is forcedto quit transmitting

8.Set Mode8458.3.10 Menu 10 DTMF First Digit Burst TimeIt often happens that the radios fail to receive the very beginning instant of eachcommunicati

8.Set Mode8468.3.11 Menu 11 Battery Type SettingSelect the correct battery type from Ni-MH battery pack and Li-ion battery pack inorder to display th

9.Cloning and Packet Operation9479. Cloning and Packet OperationThe memory data and customized operational parameters can be transferred from aMaster

9.Cloning and Packet Operation9489.1.3 Master Unit Operation1. In the Clone mode, press the PTT key of themaster unit. "SD***" is displayed

9.Cloning and Packet Operation949Packet operation is one of the data communication methods, which enables datatransmission and reception with a person

Warning5Handling this productAbout chargersAbout power supplyDo not plug multiple devices including the power supply into a single walloutlet. It may

10.Maintenance and Reference105010. Maintenance and ReferencePlease check the list below before concluding that the unit needs to be serviced. If apr

10.Maintenance and Reference105110.2.1 All ResettingWhen you reset the unit, all settings are returned to the initial factory settings. Thereset dele

10.Maintenance and Reference1052EBP-71 Li-ion Battery Pack (7.4V 1200mAh)EDC-164T/E/UK Li-ion Battery Charger (T: 120V E: 230V UK: 230V UK plug)EME-

10.Maintenance and Reference105310.3.2 Using the ChargersCharging with the EDC-165 (Trickle Charger)Please make sure that following items are included

10.Maintenance and Reference10544. After charging time is elapsed (page 52), remove the battery pack from the basket.The red indicator stays turned on

10.Maintenance and Reference10553. Mount the battery (with or without being attachedto the unit) in the basket as shown. Turn off theunit while charg

11.Specifications115611. SpecificationsGeneralFrequency range T: TX144~147.995MHz * 144~147.995MHzRX136~173.995MHz * 144~147.995MHzE: TX144~145.995MHz

11.Specifications1157TransmitterOutput power (Approx.): 5W (High)/2W (Middle)/0.5W (Low)Modulation: Variable reactance frequency modulationMax. deviat

58The following table lists available characters.

Warning6Cigar-lighter cableIn case of emergencyIn case of the following situation(s), please turn off the product, switch off the sourceof power, then

Printed in JapanCopyright Alinco, Inc. PS0572/FNNL-NL1234567891011FeaturesAccessoriesNames and Operations of PartsBasic OperationUseful FunctionsSelec

Warning7CautionEnvironment and condition of useAbout transceiverAbout power supplyWhen a charger is powered from an external DC power source (adapter,

Warning8LightningAny person is not safe outdoor during thunderstorm and lightning. This condition isgetting worse if somebody keeps a hand-held radio;

Introduction9IntroductionThank you very much for purchasing this excellent Alinco transceiver. Our productsare ranked among the finest in the world.